Repotec Powerline 85M Manual do Utilizador descarregar pdf (Página 7)

4. I

NSTALLING

OWER

INE

85 E

THERNET

DAPTER

AdvaTel PowerLine 85 Ethernet Adapters plug into wall mounted mains power points for

connecting Ethernet enabled devices over internal electrical wiring. It is suitable for use

between computers, routers, switches, hubs, access points, and gaming consoles.

IMPORTANT:

 The adapter is for indoor use only

 Data rates may vary depending on the premises mains electricity wiring

 For best performance plug the adapter directly into a wall mounted mains

power point. Avoid plugging the adapter into power boards, surge protectors,

and extension cords.

Step 1 – Connect to Mains

Plug each adapter into a wall mounted power point located near the equipment to be

connected. Check that the Power LED (top) on the adapter is lit to indicate a connection to

mains power.

Step 2 – Check Communication

When plugging in the second (or an additional) adapter. check that the Power Line

Communication LED (middle) lights to indicate connection between adapters. It takes a few

seconds to stabilise after the adapter is first plugged in. If the PCL remains off after a minute

or two then the unit has failed to find other adapters in the same network. This may be due

to an incorrect Private Network Name being set (see Privacy section below) or because of

unsuitable mains wiring.

Step 3 – Connect to Ethernet

Next, connect the Ethernet cable between the adapter and your Ethernet device at each

location. The Ethernet indicator (bottom) lights to show successful cable connection.

Privacy

The PowerLine 85 Ethernet Adapter uses its Network Name as the password key to encrypt

data. A public Network Name (HomePlug) is set as default during manufacture. This

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Sem comentários

Repotec Powerline 85M Manual do Utilizador Página 7